There are several reasons why your pet's gold does not heat up. However, heating problems are often caused by improper installation practices.
If the bottom of the petticoat is not warming up, you need to clean it. The initial warming of the bottoms of the honeycombs, which give equally heat, means that the honeycomb has accumulated underneath the honeycomb. Since the water in the pipes does not travel quickly, the honeycombs do not warm up. You can make the honeycomb warm up by adjusting the regulation.
The return position of the petals should be adjusted so that the position of the opening is close to the valve under the petticoat. The nearest valve is too low, the farthest valve must be very open. These settings may vary depending on each house and facility.
Heater Heats Up
If there is no abnormal temperature difference between the upper side and the lower side, you should definitely use protective medicine after clearing the pads.
If the heating pads are burning at the bottom, the honeycomb connections should be checked. To understand this, close the combi and wait 45 minutes. You can detect the non-burning location after you restart the boiler.
If no honeycomb flakes are burned except for the nearest honeycomb, the circulation pump of the filter and combination under the combination must be checked. The coldness of the bottom of the combine does not mean that the combination is defective.
An additional pump can be connected to the bottom of the combi boiler if they still do not burn properly. When a non-combi boiler is connected to the pump, it is obligatory to put one equilibrium container in order to operate at the same speed as the combi boiler pump. The equilibrium will ensure that the air formed in the system is thrown away.
If there are very large temperature differences between the honeycombs in different rooms, you have to tighten the honeycomb valve in the rooms which are very hot.
It is normal that there is a temperature difference between the farthest honeycomb and the nearest honeycomb. However, in order to avoid this, the mobile system may be equipped with a heating system.
There may be fugitives on the pipeline leading to the non-warming shade. The six unheated honeycombs may have come to an illegal lane that is often too small to be noticed. In this case you should get professional help.
The check valves (upper valve) and return valve (lower valve) should be checked for openings.
The top of the honeycombs has purger for venting. Until the air is exhausted, the air in the petticoat is taken until the water arrives. When the purge is switched on, it must be opened counterclockwise and close clockwise. When venting, the honeycomb valves must be in open position. The cockpit valve closes clockwise and opens counterclockwise. The water pressure at the installation will be reduced while the bleed operation is being performed. Please note that the water level in the boiler installation, boiler installation is between 0.7 bar and 1.5 bar.
By applying these methods you can find a solution to the problem of not heating the honeycombs.
Hiç yorum yok:
Yorum Gönder